View full version: Second Generation "The Ball" Dysons.
1 2 3 4 5 6 »
  1. DC 75 , motor failure/burnout
  2. DC40 - vacuum shuts off after 5-15 min, starts working 1-2 hour later
  3. dyson up22 head
  4. Dyson dc75 brushbar
  5. DC75 head issue
  6. Change Over Valve Question
  7. DC41 problem
  8. Sucking Air at Dust Bin-Cyclone Junction--Faulty Gasket?
  9. dyson up22 noise
  10. dyson dc40 brush head
  11. Dyson up22
  12. dc40 strip: request advice
  13. Compatibility question?
  14. DC40 ERP brush bar motor (only) testing
  15. PCB's for DC50 and UP15 Small Ball: Identical?
  16. Dyson DC40 non-ERP: no power to Brushroll?
  17. Replacing the Dyson DC41 Cyclone catch?
  18. DC40 filter whine
  19. Dyson Ball Animal 2 (UP24) - Brushbar not spinning
  20. Dyson DC40 Swivel Lock Arm 922559-01 - 3D print model
  21. Dyson DC40 Mk1 (Pre EU) - Stripdown and Refurbishment
  22. DC40 - Handle release lock, what operates it to allow recline ?
  23. dc40/41 changeover valve hose
  24. Dyson DC 40 Mark1
  25. brush roll intermittent
  26. UP22 Brush head stripdown
  27. saucepans
  28. Replacing changeover valve/hose on UP22
  29. Where to buy a replacement brushroll drive cog? (ours on DC41 snapped)
  30. Dyson Up15 Brushbar Not Working - Faulty PCB?
  31. DC41 soleplate wheel axle
  32. DC75 hard to push back to upright position
  33. Intermittent brush bar fault
  34. DC40 dismantling problems
  35. Identify what this part is
  36. UP24 Motor Fitment
  37. DC50
  38. Dyson ball plastic
  39. Dc40 head
  40. How to fit a DC41 cyclone release catch?
  41. Dc41 mk2 Problem standing up after int hose replace
  42. Small Ball Allergy
  43. 'Slim Ball' Upright—Loosing Section at Dust Bin/Cyclone Junction
  44. Anyone done a DC75 Big Ball Cinetic Motor Yet? SDS1553AZFA
  45. Dc40, 41, 55 - Are brush heads interchangeable?
  46. Small Ball Allergy - Tools
  47. DC 41 Mk 1 Motor Replacement - Advice needed
  48. Dyson UP22 Light Ball Multifloor: Tool Holder?
  49. DC40 Brushroll Puzzle
  50. DC55, Brush bar intermittent fault, bit of advice?