Hi All,
I have a DC18 to repair. On inspection it was evident that the wiring loom had gone open circuit so i ordered one of these.
Ive fitted it and the brush still wasn't going around.
I removed the motor and hooked it up to a DC power supply as the voltage went up it began turning, so the motor must be fine.
I have buzzed out the power switch and brush switch and there is continuity to the 2 pins where the brush head connect.
I suspect it could only be the PCB or brush reset switch ? but i cannot see any obvious defect on the PCB and there is also continuity between the reset switch.
Any ideas ?