Author Topic: Z61a handheld (Read 5794 times)

autovac01 · « **on:** August 23, 2014, 04:44:41 pm »

Anyone worked on one of these?
The brushroll is sticky but I cannot take apart to inspect

Parwaz7862 · « **Reply #1 on:** August 24, 2014, 10:07:07 am »

I had one, really good damn powerful handheld! I dont think you can take the brush cover off without breaking it, or if I'm wrong, there may be screws behind the cover, be careful though because its a really good vacuum

Parwaz7862 · « **Reply #2 on:** August 24, 2014, 10:09:03 am »

I took mine part, on the left side of the vacuum there are visible screws, check the other side if there is, and it's been ages since I took mine prt, but I no longer have it. I do remember that two screws are under the brushbar sole plate

autovac01 · « **Reply #3 on:** August 26, 2014, 10:49:45 am »

Thanks for that, renewed confidence to have another go.

autovac01 · « **Reply #4 on:** August 28, 2014, 12:04:03 pm »

They have moulded plastic over the screw on soleplate, (knew we've done them before) so we drilled it out & got inside.
The brushroll was gunked up but also the switch is dodgy.