Author Topic: x2 Dyson DC01 Refurb (Read 13651 times)

Dyson2000 · « **Reply #15 on:** October 16, 2015, 05:32:37 PM »

Removed the filter cover.

The wheels removed.

Now the Cable and Switch.

Unhook the switch and then the block connector.

Cable off.

Now the motor, undo 6 screws

Dyson2000 · « **Reply #16 on:** October 16, 2015, 05:45:36 PM »

And its Out.

The cyclone.

Removed the release valves.

undone that screw near the handle, gave it a tug. and its off.

This bit was a pain in the arse. Did get it eventually.

Washed everything ,dried it nicely with the hair dryer. just need to put it all back together.

Dyson2000 · « **Reply #17 on:** October 16, 2015, 05:54:29 PM »

Before i continued on. I had this

Started off by putting the cyclone all back together.

Then the motor and hooking the wires on the RIGHT way, putting the six screws back in.

The Kick plate on

Its starting to look like a DC01 now.

I put the cable threw the hole and hooked it all up.

Dyson2000 · « **Reply #18 on:** October 16, 2015, 06:00:16 PM »

put that plastic cover back on.

The brush bar all greased up and a new belt on.

The Sole plate on.

The wand and hose back on.

New filters in all round.

Done!. That's much better i must say.

Dyson2000 · « **Reply #19 on:** January 24, 2016, 11:05:55 PM »

I might buy this one and strip it for our hoover. its a minter though!, might just swap the motor for our one because its practically new.

beko1987 · « **Reply #20 on:** January 25, 2016, 08:51:28 AM »

No, don't strip that! I'll have it if you don't want it and can post! That's the DA001 style font, but the DC01 branding, so an early DC01!

Looks unfaded too. Don't break it for spares!

Dyson2000 · « **Reply #21 on:** January 25, 2016, 03:55:05 PM »

Quote from: beko1987 on January 25, 2016, 08:51:28 AM

No, don't strip that! I'll have it if you don't want it and can post! That's the DA001 style font, but the DC01 branding, so an early DC01!

Looks unfaded too. Don't break it for spares!

yeah I know but our hoover needs something to get it back to the way it was. I can't find anything otherwise I would. but that's what our hoover looks like when it was new.

MVacs · « **Reply #22 on:** January 25, 2016, 08:18:08 PM »

If it has a fixed soleplate, I'll buy that and the bin flap if you are breaking it.

Dyson2000 · « **Reply #23 on:** March 22, 2016, 02:32:55 PM »

I eventually made my mind up. The motor from our one went into that blue DC01 and is perfect now, Then bought a early DC01 off eBay not to long ago. And used the Parts to get it up to tip top condition. Ah, Perfect.