The World's #1 Vacuum Cleaner Advice, Repair, Discussion & Information Forum

Author Topic: DC24 PCB BOARD  (Read 5343 times)

Offline dsam

  • Member
  • Posts: 35
  • Country: gb
  • Gender: Male
Re: DC24 PCB BOARD
« Reply #15 on: September 03, 2018, 03:32:42 PM »
No, check for a dc voltage at b.bar motor end about 330 volts dc

Offline ryevac

  • Member
  • Posts: 610
  • Country: gb
  • Gender: Male
  • Optimism is the faith that leads to achievement
Re: DC24 PCB BOARD
« Reply #16 on: September 03, 2018, 03:38:54 PM »
Only you can do that, you need a volt / ohm meter to test the bridge rectifier & 1 ohm resistor as well as any other components on the board.

was the yoke cable ok ?
I have a 24 on the bench actually for service so will take a couple of pics... if required
The only way to fail is not to try.


 

 

Trade Dyson Spare Parts

 

 

Dyson Spare Parts

 

 

Freestanding Dyson Cordless Vacuum Stand

 

 

Buy a Dyson DC04 Wand Handle

 

 

 

 

Buy a police truncheon

 

 

Instagram

Dyson Spares, Parts, Advice   Follow us on Twitter

Manchester Vacs on Instagram