I have a DC18, where motor overheats and it shuts down after a few mins(4-5mins).
It doesn't happen immediately, brush rolls and its sound changes like it's about to die and then it'll shut off.
Cleaned all the wand, pipes, lower brush area and all filters. If I remove the whole cyclone and filter body, then turn it on there's a lot of suction on the hole which goes into the cyclone. While running, wand has very minimum suction.
I feel like, there's some blocking, cleaned the port where wand hose goes yesterday, there was a lot of debris/hair there. In order to access it, have to disassemble all the springs and torx screws, now have to assemble, is there a exploded diagram? Also, while I am at it any other cleaning I can do?Thank you for the advise and help.