The World's #1 Vacuum Cleaner Advice, Repair, Discussion & Information Forum

« previous next »
Pages: [1]   Go Down

Author Topic: DC24 Brush Head PCB Question  (Read 2394 times)

Offline DavidB

  • Member
  • Posts: 1
DC24 Brush Head PCB Question
« on: January 13, 2020, 12:20:09 pm »
I have just checked the PCB on my broken DC24 brush head and can see the same fried component as shown on an earlier post. It has R1 against it so I reckon it is a resistor. Can this be replaced, if I knew the resistance value of course? If not where do you get replacement PCBs and how much are these?
Logged

Offline ryevac

  • Member
  • Posts: 626
  • Country: gb
  • Gender: Male
  • Optimism is the faith that leads to achievement
Re: DC24 Brush Head PCB Question
« Reply #1 on: January 13, 2020, 06:45:06 pm »
1 ohm 5watt wirewound i believe.

The head motor failing kills it.
Logged
The only way to fail is not to try.

Offline ryevac

  • Member
  • Posts: 626
  • Country: gb
  • Gender: Male
  • Optimism is the faith that leads to achievement
Re: DC24 Brush Head PCB Question
« Reply #2 on: January 14, 2020, 10:12:10 pm »
or 2.5watt / can't remember now but i think this component has been posted before
Logged
The only way to fail is not to try.
Pages: [1]   Go Up
« previous next »
 

 

Trade Dyson Spare Parts

 

 

Dyson Spare Parts

 

 

Freestanding Dyson Cordless Vacuum Stand

 

 

Buy a Dyson DC04 Wand Handle

 

 

 

 

Buy a police truncheon

 

 

Instagram

Dyson Spares, Parts, Advice   Follow us on Twitter

Manchester Vacs on Instagram