The World's #1 Vacuum Cleaner Advice, Repair, Discussion & Information Forum

Author Topic: DC25 No Power to the Cleaner Head: MV Yoke Loom Fitting Instructions  (Read 7542 times)

Offline Brody2009

  • Member
  • Posts: 9
Re: DC25 No Power to the Cleaner Head: MV Yoke Loom Fitting Instructions
« Reply #15 on: October 05, 2022, 06:25:01 pm »
Thanks, will check these.  Hard to tell what they should look like after years of use, compared to new parts.  thanks.

Offline dr_barnowl

  • Member
  • Posts: 1
Re: DC25 No Power to the Cleaner Head: MV Yoke Loom Fitting Instructions
« Reply #16 on: January 16, 2024, 01:59:11 pm »
Arrived here with the symptoms of ...

- The brushbar runs, but only for a few seconds after the head reclines
- Load doesn't make a difference (stops on carpet or just lying down)

Would that be consistent with this fault? Feels like maybe there's enough wire left to conduct but it overheats rapidly and makes the wire bend and break the connection, which makes it stop until you trip the reset?

Online MVacs

  • Administrator
  • Member
  • *****
  • Posts: 6424
  • Country: gb
  • Gender: Male
    • Manchester Vacs - The Independent Dyson Specialists
Re: DC25 No Power to the Cleaner Head: MV Yoke Loom Fitting Instructions
« Reply #17 on: January 16, 2024, 02:58:39 pm »
What you describe sounds more like a brush bar motor or a reset button.


 

 

Trade Dyson Spare Parts

 

 

Dyson Spare Parts

 

 

Freestanding Dyson Cordless Vacuum Stand

 

 

Buy a Dyson DC04 Wand Handle

 

 

 

 

Buy a police truncheon

 

 

Instagram

Dyson Spares, Parts, Advice   Follow us on Twitter

Manchester Vacs on Instagram

Registration