Dyson & Sebo Vacuum Cleaner Repair & Advice Forums
Dyson Models => Dyson DC14, DC17, DC27, DC28 and DC33 => Topic started by: sastek on November 23, 2011, 11:56:28 pm
-
Hi all,
I wonder if someone can tell me what parts I would need to change the USA Panasonic 110v motor to a Ydk 240v one
Thanks
Stu
-
I remember we supplied some parts for someone that came back from America with a similar problem. I think we sent a full motor casing with the motor.
But, we should wait for our member Vacuum Cleaner House to see this as he will know for sure.
-
Hi sorry for the late reply , all he will need is the front motor rubber and the ydk motor. He is lucky those usa versions have a much better brush roll and clean allot better
-
Hi sorry for the late reply , all he will need is the front motor rubber and the ydk motor. He is lucky those usa versions have a much better brush roll and clean allot better
By front, you mean the small motor rubber? The casing, retainer and back rubber are the same?
-
By small do you mean the one at the back spindle side ? no hat stays the same, the big one in front by the fan that needs to be changed , but just check does he have a panasonic or ydk motor. if its ydk he just needs the motor.
-
He has a Panasonic one he says in the OP.
So he just needs a YDK replacement and the bigger of the two rubbers then?
-
yep thats it and some new filters, especially the hepa one. can' fit new motor with old filters :)
-
Hi guys, thanks for the replies, unfortunately, for me, I have already placed an order for a used housing, both rubbers and a motor from MVacs, not a probelm really cos the used mottor and rubbers were only a tenner!
Big thanks for the advice though :thumbsup: