Dyson & Sebo Vacuum Cleaner Repair & Advice Forums

Dyson Models => Dyson DC14, DC17, DC27, DC28 and DC33 => Topic started by: mancalvo1 on June 26, 2012, 12:26:53 am

Title: Dyson DC17 (USA) How does the upright microswitch sit inside LMC Motor housing?
Post by: mancalvo1 on June 26, 2012, 12:26:53 am

Dyson DC17 (USA)

1. How does the upright micro-switch sit inside LMC Motor housing? I want to replace the switch, but I need a picture to show the position and location inside the motor housing.. Cheap help took it apart and now I need to put it back together >:( the exploded diagram does not show the exact location and orientation.

Thanks!

Manolo

Title: Re: Dyson DC17 (USA) How does the upright microswitch sit inside LMC Motor housing?
Post by: mancalvo1 on June 26, 2012, 10:38:25 pm

I figure it out.. I don't need any help for right now.. The upright micro switch gets inserted into a cavity of the lower motor housing cover and onto the side of the plastic actuator. the wires are tucked into the routing slots, which hold the wires in place.

Title: Re: Dyson DC17 (USA) How does the upright microswitch sit inside LMC Motor housing?
Post by: mancalvo1 on June 26, 2012, 10:41:38 pm

Correction: upper housing cavity since you will be working with the pre-filter cover sitting on top of the table and the hose/arm hanging down towards the floor. The pre-filter cover is flat and therefore is stable when working on this area.