Dyson & Sebo Vacuum Cleaner Repair & Advice Forums

Other Vacuum Cleaners & Site Suggestions => Discussion About Other Vacuum Cleaners & Appliances => Topic started by: autovac01 on August 23, 2014, 04:44:41 pm

Title: Z61a handheld
Post by: autovac01 on August 23, 2014, 04:44:41 pm

Anyone worked on one of these?
The brushroll is sticky but I cannot take apart to inspect  :'(

Title: Re: Z61a handheld
Post by: Parwaz7862 on August 24, 2014, 10:07:07 am

I had one, really good  damn powerful handheld! I dont think  you can take the brush cover off without breaking it, or if I'm wrong, there may be screws behind the cover, be careful though because its  a really good vacuum

Title: Re: Z61a handheld
Post by: Parwaz7862 on August 24, 2014, 10:09:03 am

I took mine part,  on the left side of the vacuum there are visible screws, check the other side if there is, and it's been ages since I took mine prt, but I no longer have it.  I do remember that two screws are under the brushbar sole plate

Title: Re: Z61a handheld
Post by: autovac01 on August 26, 2014, 10:49:45 am

Thanks for that, renewed confidence to have another go.

Title: Re: Z61a handheld
Post by: autovac01 on August 28, 2014, 12:04:03 pm

They have moulded plastic over the screw on soleplate, (knew we've done them before) so we drilled it out & got inside.
The brushroll was gunked up but also the switch is dodgy.

Title: Re: Z61a handheld
Post by: Parwaz7862 on August 28, 2014, 07:35:57 pm

Cool, had to throw mine away cos the switch had gone, would be nice of it had just "on" and "off" and that's it tbh